2004 Ford Pickup
Mileage
145,018
Service Date
7/5/2022
Services Performed
- HAD CODE P0340 CAM POSITION SENSOR A INSPECTED WIRING TO CAM SENSOR TESTED GOOD REMOVED AND REPLACED CAM SENSOR CLEARED CODE AND TEST DROVE CODE DID NOT RESET
- CLIENT REQUESTS UTAH EMISSIONS INSPECTION FOR REGISTRATION RENEWAL.
- CLIENT REQUESTS MINOR MAINTENANCE SERVICE TO INCLUDE SEMI SYNTHETIC OIL CHANGE, WITH UP TO 5 QUARTS OF 10/30 SEMI SYNTHETIC OIL, NEW OIL FILTER, INSPECT CONDITION OF ALL OTHER FLUIDS AND TOP OFF AS NEEDED, INSPECT AIR FILTER, PERFORM MAINTENANCE INSPECTION AND CHECK AND ADJUST TIRE PRESSURES. ADVISE CLIENT OF ANY NEEDED REPAIRS OR SERVICE.
- REMOVED AND REPLACED FUEL FILTER
- CHECKED FOR ENGINE NOISE FOUND IDLER PULLEY CAUSING NOISE INSTALLED NEW IDLER AND TENSIONER PULLEYS AND DRIVE BELT RETESTED FOR NOISE WAS GONE
- REMOVE BATTERY CABLES, WIRE BRUSH AND CLEAN CONNECTIONS AND TERMINALS. REASSEMBLE AND TORQUE TO SPEC. APPLY TERMINAL PROTECTANT.
- FOUND RIGHT OUTER TIE ROD AND LEFT FRONT WHEEL BEARING HAD EXCESSIVE PLAY INSTALLED NEW WHEEL BEARING AND TIE ROD END PREFORMED ALIGNMENT TEST DROVE NO PROBLEMS ON TEST DRIVE
- CLIENT REQUEST SUBLET FOR FRONT END ALIGNMENT SERVICE. INVOICE#19412
- FOUND ENGINE MOTOR MOUNTS HAD EXCESSIVE MOVEMENT INSTALLED BOTH MOTOR MOUNTS AND TEST DROVE THUMPING NOISE ON TAKE OFF IS GONE NOW
BOBBY M. gave our service a 5 star review on 7/6/2022
