Nissan Archives - Evans Automotive Inc

2014 Nissan Versa Note
Mileage
58,956
Service Date
5/20/2025
Services Performed
Checked the Vehicle over and found no issues with the Transmission. Note this is a CVT Trans and there is no Adjustment that can be made. Work Performed, checked the Vehicle for Trans Fault Codes and found none. When working on Vehicle, found loose Engine Mount that may have been the noise client was hearing. Tightened Mount and re checked. No noise at this time. Completed, no other problems found at this time.
JULIE M. gave our service a 5 star review on 5/21/2025
2011 Nissan Rogue
Mileage
150,864
Service Date
4/30/2025
Services Performed
Tested vehicles A/C for stop leak, test passed ok. Connected gauges to A/C system. System pressure was high. LOW 116PSI, HIGH 190PSI. Recovered A/C system. System was low on refrigerant 0.15KG. Recharged with 0.50KG of refrigerant. System is producing 43F from center vents on max A/C. A/C system seems to be working as intended.
BAILEY H. gave our service a 5 star review on 5/2/2025
2015 Nissan Altima
Mileage
157,968
Service Date
2/6/2025
Services Performed
CHECKED ALL FLUIDS,TIRE PRESSURES AND OVERALL CONDITION OF CAR COMPONENTS BRAKES FRONT = 8mm REAR = 6mm Found that the coolant was low. Topped it off. Found that the Power steering fluid is dirty and recommend a power steering flush. Declined at this time. Found the front wheel bearings to be loose and making a lot of noise. Replace wheel bearing. Declined at this time. When test driving found that the transmission shifts hard in low gears. Racked vehicle up and got a fluid sample found it to be extremely dirty, and full of metal. Pulled codes and found that the transmission has a P17F0 transmission judder. Replace transmission. Declined at this time. Topped off Coolant.
CLIENT REQUESTS UTAH EMISSIONS INSPECTION FOR REGISTRATION RENEWAL. COMPLETED AND PASSED ENMISSIONS.
LYNN W. gave our service a 5 star review on 2/7/2025
2014 Nissan Versa Note
Mileage
55,881
Service Date
11/19/2024
Services Performed
Check cooling fan found fan fuse to be blown caused by shorted fan motor , check fan motor found it seized motor Removed core support to access cooling fan, removed and replaced with new fan . Ran vehicle to operating temp, and checked fan, and the fan functions properly at this time. complete.
Scanned for codes and found P0302 misfire detected,P0420 Catalyst efficiency below threshold bank 1. and engine cooling fan inoperative and transmission wont up range and jerking Inspected spark plugs and found carbon tracking found seized cooling fan motor need to repair cooling fan and repair miss and recheck transmission and converter
work performed test drove vehicle and found the vehicle is not ranging up on test drive. scanned and found no codes in the vehicles pcm checked the transmission fluid and found the transmission fluid to be full of metal . remove transmission and installed new transmission with dealer required install kit when draining the transmission pan before transmission removal the pan was full of metal . flushed cooler with dealer supplied flush .sent the vehicle to the dealer and had transmission and vehicles ecm and tcm programmed to the latest software. after programming test drove vehicle to verify that the vehicles transmission works properly at this time.
TIM DAHLE NISSAN PROGRAMMED VEHICLES TRANSMISSION PER THE WARRANTY COMPANIES REQUEST. INVOICE#10070971
JULIE M. gave our service a 5 star review on 11/20/2024
2015 Nissan Murano
Mileage
97,343
Service Date
9/11/2024
Services Performed
Took on test drive and heard a squeaking noise from the brakes. Inspected brakes and found that brakes measure 8/32 in the front and 5/32 in the rear. Found that the brakes were not lubed and are showing signs of rust on the contact points. Cleaned and lubed front and rear brake pads. Took on test drive and listened for brake noise and could not hear squeaking. Complete
GARY S. gave our service a 5 star review on 9/19/2024
2008 Nissan Rogue
Mileage
128,817
Service Date
8/2/2024
Services Performed
CHECK NOISE WHEN FIRST STARTED
CHECK DASH MISSING PARTS
CHECKED ALL FLUIDS,TIRE PRESSURES AND OVERALL CONDITION OF CAR COMPONENTS BRAKES FRONT = REAR =
JORGE N. gave our service a 5 star review on 8/5/2024
2019 Nissan Versa Note
Mileage
56,891
Service Date
6/27/2024
Services Performed
Check and adjust serp belt and rechecked completed
KAITLYN T. gave our service a 5 star review on 6/28/2024
2014 Nissan Sentra
Mileage
96,131
Service Date
2/28/2024
Services Performed
Inspected vehicle confirmed malfunction indicator light is illuminated. Scanned vehicle found code P0507 – Idle air control system idle high. Inspected throttle body and found throttle body is contaminated. Cleaned throttle body, performed idle air control relearn. Performed drive cycle to readiness. Performed emissions, vehicle passed Davis county emissions.
LOLA W. gave our service a 5 star review on 2/29/2024
2017 Nissan Altima
Mileage
69,541
Service Date
3/29/2023
Services Performed
Scanned all control modules for relevant faults- found P2004, Swirl Flap fault stored in powertrain controller. Visually inspected intake manifold, control motor, and position sensor for obvious faults or loose connections- none found. Commanded swirl flap motor open and closed numerous times while monitoring position sensor to evaluate system performance- flaps opened and closed as expected every time. This application is known for intermittently sticking tumble flap mechanisms, and intake manifold has been re-designed to eliminate failures. Recommend replacement of intake manifold and associated parts at this time. Customer declined further repairs.
ERIC F. gave our service a 5 star review on 3/30/2023
2013 Nissan Pathfinder
Mileage
177,255
Service Date
3/23/2023
Services Performed
Scanned all control modules for relevant faults- none found. Noted P0502, "Engine oil pressure sensor circuit." Checked for spark from ignition coil while cranking- coil would only spark one time each attempt to start. Unplugged #4 injector and installed diagnostic light, noted similar behavior to ignition coil. Ensured fuel pressure was correct and fuel pump was capable of supplying proper volume of fuel to rail. Attached laboratory oscilloscope to crankshaft position sensor circuit AND both camshaft position sensor circuits and obtained waveform while cranking. Waveforms appeared correct, and upon further analysis and comparison to known good captures, basic engine timing was deemed to be OK. Checked all power and ground circuits at engine controller, all tested good. Obtained used engine controller and installed, programmed immobilizer and ignition key to controller, and engine still would not start. Rechecked all previously performed inspections and tests; no further faults found. Manually powered all fuel injectors and then triggered them while analyzing resultant waveform with lab scope, not problems found. Obtained NEW OEM crankshaft sensor and installed to engine- engine started and ran properly. Reassembled vehicle complete and performed test drive. NOTE: Engine oil pressure sensor harness is frayed, connector is missing. Harness repair will be required.
JULIE L. gave our service a 5 star review on 3/30/2023

Nissan

We Service and Repair all Nissan cars